Operation; The On/Off Button; The Indicator Lamp; To Start The Product - Husqvarna AUTOMOWER 305 Operator's Manual

4.1 The ON/OFF button

WARNING: Read the safety
instructions carefully before you start
the product.
WARNING: Keep your hands and feet
away from the rotating blades. Never
put your hands or feet close to or
under the machine when the motor is
running.
WARNING: Do not use the product
when persons, especially children, or
animals, are in the work area.
• Push the ON/OFF button for 3 seconds to
switch on the product. The product is active
when the indicator lamp on the keypad is lit.
• Push the ON/OFF button for 3 seconds to
switch off the product.
• The product is in power save mode if the
indicator lamp flashes. Push the ON/OFF
button for 3 seconds to switch on the
product.

4.2 The indicator lamp

WARNING: It is only safe to carry out
inspection or maintenance on the
product when the product is disabled.
The product is disabled when the lamp
on the keypad is not lit.
1462 - 001 - 24.02.2020

4 Operation

The indicator lamp on the keypad is an important
status indicator:
• The product is active if the indicator lamp
lights continuously.
• The product is in power save mode if the
indicator lamp flashes. Push the ON/OFF
button for 3 seconds to make the product
active again.
• The product is disabled when the indicator
lamp is not lit.

4.3 To start the product

1. Open the hatch to the keypad.
2. Push the ON/OFF button for 3 seconds. The
display is lit up.
3. Use the up/down arrow buttons and the OK
button to enter the PIN code.
4. Push the START button.
5. Select the desired operating mode and
confirm with the OK button. Refer to
Operating mode Start on page 35 .
6. Close the hatch.
Note: If the product is parked in the charging
station, the product only leaves the charging
station when the battery is fully charged and if the
schedule allows the product to operate.
Note: The first weeks after installation the
perceived sound level when cutting the grass
may be higher than expected. When the product
has cut the grass for some time, the perceived
sound level is much lower.

4.4 Operating mode Start

Push the START button to select the following
operating modes:
Main area
•
Secondary area
•
Override schedule
•
Spot cutting
•
Operation - 35