Printed Circuit Board Replacement; Sensor Replacement - Teledyne HASTINGS HFM-300 Instruction Manual

Hide thumbs Also See for HASTINGS HFM-300:

Table of Contents

reverse order of disassembly. A new nickel gasket will be required. Secure the endcap with 65 in lb.

(7.3 N m) to 85 in lb (9.6 N m) of torque on each stainless steel socket head cap screw. Use of a

fastener other than the one mentioned here may result in leakage at the seal. Recalibration of the

Hastings 300 is necessary.

3.4. Printed Circuit Board Replacement

NOTE: This instrument contains static sensitive PC boards. Maintain static protection when handling

the PC boards.

In the event that any of the PC boards fail, they are easily removed from the instrument and replaced

with a spare. This ease in disassembly and replacement substantially reduces instrument downtime.

Replacement of the 4-20 mA option PC board: Unplug the power cable from the instruments "D"

connector. Remove the fasteners and steel can. The 4-20 mA board is the PC board marked

PC854 in the lower left-hand corner just above the Teledyne logo. Remove the screws and lift

off the 4-20 mA board. Be careful not to damage the main board and 4-20 mA board connectors.

Replacement of the main PC board: Unplug the power cable from the instruments "D"

connector. Remove the fasteners and steel can. Remove the 4 screws which fasten the main PC

board to the sensor module. Gently unplug the main board from the sensor (and from the

4-20 mA board, if present).

Follow instructions for removing the PC board(s) as described in Section 4.5. Remove the 4 Allen head

cap screws that fasten the sensor to the main instrument base. Remove the sensor module from the

base, discarding the used nickel gaskets. New nickel gaskets are required for re-assembly.

To place an order or to obtain information concerning replacement parts, contact the factory

representative in your area. See the last page in this manual for the address or phone number. When

ordering, include the following information: Instrument model number, part description and Hastings

part number.

Manual: 151-032015 300-302 Series

Page 18 of 22

Table of Contents

Hastings hfc-302