Samsung OfficeServ 7200 Technical Manual page 53

Table of Contents
Home Page
OfficeServ 7200 INSTALLATION
TECHNICAL MANUAL PART 3 SEPTEMBER 2005
Figure 3.35 SVMi-20E/HD with no optional boards installed (LEFT)
and SVMi-20E/CF with all components installed (RIGHT)
INSERTING THE CARD
NOTE: Before powering off the KSU, it is recommended that you use MMC 740 and set
MBX Download to 'No'.
The SVMi-20E card can be installed in any slot (1 ~ 5) of any cabinet. Check that the
OfficeServ 7000 Series System's power switch is in the OFF position. Next position the
SVMi-20E card in the grooves of the card guide and gently slide the card in until it
makes contact with the connector. Press gently but firmly on the left and right of the
front edge of the card until the card seats in its connector. Press firmly on the Black
Front Panel Lever until it snaps securely in place. The cabinet can now be turned on.
If the SVMi-20E card is being installed in an existing (not new) system, you will have to
use MMC 806 to pre install the card and MMC 724 to assign extension numbers to
each SVMi-20E port. Use any available numbers.
After the SVMi-20E card is installed, either in a new or existing system, you will have to
use MMC 601 and assign all the SVMi port numbers to the last available station group
(Group Number 5039 by default).
3.35