Technical Specifications - Shure Performance Gear Manual

Technical Specifications

System
Working Range
Audio Channel Response
Total Harmonic Distortion
Dynamic Range
Operating Temperature
Range
Transmitter Audio Polarity
PG1 Bodypack Transmitter
Audio Input Level
Gain Adjustment Range
Input Impedance
RF Transmitter Output
Dimensions
Weight
Housing
Power Requirements
Battery Life
PG2 Handheld Transmitter
Audio Input Level
Gain Adjustment Range
RF Transmitter Output
Dimensions
Weight
Housing
Power Requirements
Battery Life
75m (250 ft.) Note: actual range depends on RF signal absorption, reflection,
and interference.
Minimum: 45 Hz.
Maximum: 15 kHz (overall system channel depends on
microphone element).
0.5%, typical
Ref. +/– 33 kHz deviation, 1 kHz tone
>100 dB A-weighted, typical
–18°C (0°F) to +57°C (+135°F)
Note: battery characteristics may limit this range
Positive pressure on microphone diaphragm (or positive voltage to tip of
WA302 phone plug) produces positive voltage on pin 2 (with respect to pin 3
of low impedance output) and the tip of the high impedance 1/4-inch output.
–10 dBV maximum at "mic" gain position
+10 dBV maximum at 0dB gain position
+20 dBV maximum at –10dB gain position
30 dB
1mΩ
10 mW typical (dependent on applicable country regulations)
110 mm H x 64 mm W x 21 mm D (4.3 x 2.5 x 0.8 in.)
75 grams (2.6 oz.) without battery
Molded ABS
One 9V alkaline or rechargeable battery
>8 hours (alkaline)
+2 dBV maximum at –10dB position
–8 dBV maximum at 0dB position
10dB
10 mW typical (dependent on applicable country regulations)
223.52 L x 53.34 Dia. (8.8 in. x 2.10 in.)
218 grams (7.7 oz.) without battery
Molded ABS handle and battery cup
One 9V alkaline or rechargeable battery
>8 hours (alkaline)