Table of Contents
Advertisement
1. MOUNTING
2°-10° transom angle (stepped transom and jet boats): Position the shim with the tapered end
down.
19°-22° transom angle (small aluminum and fiberglass boats): Position the shim with the ta-
pered end up.
3. If the bracket has been temporarily fastened to the transom, remove it. Apply a marine sealant
to the threads of the three #10 x 1-1/4" self-tapping screws to prevent water seeping into the
transom. Screw the bracket to the hull. Do not tighten the screws completely at this time.
4. Repeat step 1 to ensure that the angle of the sensor is correct.
Note: Do not position the sensor farther into the water than necessary to avoid increasing
drag, spray, and water noise and reducing boat speed.
5. Using the vertical adjustment space on the bracket slots, slide the sensor up or down to pro-
vide a projection of 3 mm (1/8"). Tighten the screws.
2°-10°
11°transom
transom angle
angle
Shim with
No shim
taper up
parallel
12°-18°
transom angle
Slight angle,
no shim
Hull projection 3 mm (0.12")
11
19°-22°
transom angle
Shim with
taper down
parallel
parallel
Cable cover
Cable cover
Cable
clamp
50 mm (2.0")
Advertisement
Table of Contents
