Chapter 2
Using the SCXI-1126
Front Connector Signal Descriptions
Pin
A2
A4, A6, A8, A10, C2,
C4, C6, C8, C10, A16,
C16, A22, C22, A28,
C28
A12, A14, A18, A20,
A24, A26, A30, A32
C12, C14, C18, C20,
C24, C26, C30, C32
SCXI-1126 Rear Signal Connector
If you are using the SCXI-1126 with an E Series DAQ device and cable assembly,
Note
you do not need to read the remainder of this chapter. If you are using the SCXI-1180
feedthrough panel, the SCXI-1343 rear screw terminal adapter, or the SCXI-1351 one-slot
cable extender with the SCXI-1126, read this section.
SCXI-1126 User Manual
SCXI-1126 front connector signal descriptions are listed in Table 2-2.
Table 2-2. SCXI-1126 Front Connector Signal Descriptions
Signal Name
CHSGND
Not Connected
CH7+ through CH0+
CH7– through CH0–
Figure 2-5 shows the pin assignments for the SCXI-1126 rear signal
connector. These signals are described in the
Descriptions
section.
Description
Chassis Ground—Connects to the SCXI
chassis.
Do not connect any signals to these pins.
Positive Input Channels—Positive inputs to
channels 7 through 0, respectively.
Negative Input Channels—Negative inputs to
channels 7 through 0, respectively.
2-6
Rear Connector Signal
ni.com