Advertisement
GEM-MFI SERIES
Final Check List: Remote
___1. Is the ice system installed
indoors in a location where air
and water temperatures are
controlled, and where they do
not exceed the design
limitations?
___2. Is there an electrical service
within sight of the installed
machine? Has the voltage
been checked, and compared
to nameplate requirements?
___3. Have all the plumbing
connections been made and
checked for leaks?
___4. Has the machine and bin
been leveled?
___5. Is there a minimum of 6
inches clearance at the rear,
left and right of the machine
for proper service access?
___6. Is the water pressure a
minimum of 20 psig?
___7. Has the machine been
secured to the bin or
dispenser?
___8. Is there a water shut off valve
installed near the machine?
___9. Is the remote condenser
installed per local codes, and
in a place where it has
adequate ventilation and
minimal solar heat gain?
___10. Has all shipping material and literature (inside front panel) been removed from the units?
___11.Have the remote condenser and pre-charged lines been properly installed?
___12. Has the electrical connection between the ice maker and condenser been made?
___13. Verify that the master switch is in the OFF position.
___14. Switch ON the electrical power.
___15. Refer to the Pre-Start instructions
Remote condenser
secured?
Plumbing?
Power Supply?
Page 18
For the Installer
Condenser Leveled?
Roof Holes Sealed?
Machine
Leveled?
Hide quick links:
Advertisement
