Samsung Multifunction MultiXpress X322 Series User Manual page 380

Solving other problems
Condition
Color or Black If the amount of background shading becomes unacceptable:
background
• Change the image transfer belt if it has reached its lifespan.
Contact a service representative.
• Check the environmental conditions: very dry conditions
(low humidity) or a high level of humidity (higher than 80%
RH) can increase the amount of background shading.
• Remove the old toner cartridge and install a new one.
Toner smear If toner smears on the page:
• Clean the inside of the machine. Cleaning the inside or
contact a service representative.
• Check the paper type and quality (see "Print media
specifications" on page 393).
• Remove the imaging unit and install a new one. Contact a
service representative.
• Change the image transfer belt if it has reached its lifespan.
Contact a service representative.
Suggested Solutions Condition
Vertical If marks repeatedly appear on the printed side of the page at
repetitive even intervals:
defects
• The imaging unit may be damaged. If a repetitive mark
occurs on the page, run a cleaning sheet through several
times to clean the imaging unit. Cleaning the inside. If you
still have the same problems, remove the imaging unit and
install a new one. Contact a service representative.
• Parts of the machine may have toner on them. If the
defects occur on the back of the page, the problem will
likely correct itself after a few more pages.
• The fusing assembly may be damaged. Contact a service
representative.
Background Background scatter results from bits of toner randomly
scatter distributed on the printed page.
• The paper may be too damp. Try printing with a different
batch of paper. Do not open packages of paper until
A
necessary so that the paper does not absorb too much
moisture.
• If background scatter occurs on an envelope, change the
printing layout to avoid printing over areas that have
overlapping seams on the reverse side. Printing on seams
can cause problems.
• If background scatter covers the entire surface area of a
printed page, adjust the print resolution through your
software application or in Printing Preferences (see
"Opening printing preferences" on page 96).
Suggested Solutions
15. Troubleshooting
380