Samsung Multifunction MultiXpress X322 Series User Manual page 370

Understanding display messages
Message
Scanner locked or The CCD (Charged
another problem Couple Device) lock has
occurred been locked.
Scan System Failure: There is a problem in the
[error number]. Turn off scan system.
then on
Sensor Failure: [error There is a problem in the
number]. Turn off then sensor.
on. Call for service if the
problem persists
Staple cartridge is empty. Small amount of staple
Replace it cartridge is left. The
estimated life of staple
cartridge is close.
• Staple cartridge is low. The staple cartridge has
Prepare it
reached the end of its
lifespan.
• Staple cartridge is low.
Replace it
Meaning Suggested solutions
Unlock the CCD lock .
Or turn the machine off
and back on again. If
the problem persists,
call for service.
Turn the machine off
and back on again. If
the problem persists,
call for service.
Unplug the power cord
and plug it back in. If
the problem persists,
call for service.
Prepare a new staple
cartridge for a
replacement.
This message appears
when the staple
cartridge is completely
empty. Prepare the
staple cartridge.
Message
Staple cartridge not The staple cartridge is not
install. Install it installed or the staple
cartridge is not properly
installed.
The temperature of this The temperature of this
machine is too low. machine is too low.
Please wait for a while to
warm up
There has been a There is a problem in the
problem with fax modem fax modem card.
card. Install again. Call
for service if the problem
persists
The ACR sensor is dirty. The ACR sensor is dirty.
Please clean it with soft
cloth or paper
The CTD sensor is dirty. The CTD sensor is dirty.
Please clean it with soft
cloth or paper
Too much paper in The finisher stacker is full. Remove printouts from
finisher stacker. Remove
printed paper
Meaning Suggested solutions
Install the staple
cartridge. If it is already
installed, try to reinstall
the staple cartridge. If
the problem persists,
call for service.
Wait for a while to
warm up.
Install the fax modem
card. If it is already
installed, try to reinstall
the fax modem card. If
the problem persists,
call for service.
Clean ACR sensor with
soft cloth or paper.
Clean CTD sensor with
soft cloth or paper.
the finisher stacker, the
machine resumes
printing.
15. Troubleshooting
370