Wall Mounting - Sonos Sub User Manual

SONOS USER GUIDE
Controls and lights
Join button
Status light
Connector panel
Ethernet ports
Ethernet ports (2)
AC power (mains) input
Select a location
If you purchased a Boost to replace a Sonos product that's connected to your router, first add the Boost to
your Sonos system, then plug it into your router and move the one that was originally wired.
If you purchased a Boost to extend the range of your Sonos system, place the Boost in between the Sonos
speaker that's out of reach and the rest of the Sonos system.

Wall mounting

Choose a location that's close to an electrical outlet (power cord length is 6 ft. / 1.8m), away from heat
1.
sources, hidden wiring, gas lines, etc.
Drive an American standard #6 round head screw (metric, M3.5 round head screw) into the wall, leaving a
2.
gap between the wall and the screw head (approximately 0.13 in / 3.3mm).
Press to connect during setup.
Indicates the status. Learn more
If the light is distracting, you can turn it off in your room's
settings.
AC power (mains) input
Use an Ethernet cable if you want to connect to a router,
computer, or network-attached storage (NAS) device
(optional).
Use only the supplied power cord (using a third-party
power cord will void your warranty).
Note: Be sure to use the proper power adapter for
your country.