Dynamic Hst Safety Stud Anchor Procedure - Life Fitness Synrgy 180 Owner's Manual

Dynamic HST Safety Stud Anchor Procedure

1. Place unit into position to be mounted.
2. If necessary, cut HST Safety Stud Anchor to length before installation, leaving enough length to ensure proper
concrete embedment (see Anchor Section for embedment depth required) and proper tightening torque (44 Foot-
Pounds/60Nm).
3. Wearing protective glasses, drill down into
flooring perpendicularly to the required depth,
ensuring that the foot thickness is being ac-
counted for; refer to Anchor Selection and Foot
Dimensions Section.
4. Clear out the debris from hole, insert fastener
and hammer into hole until flush against frame
plate.
5. Tighten to 44 Foot-Pounds (60Nm).
6. If necessary, cut extra length from top of anchor with a rotary tool leaving proper concrete engagement and torque
requirements.
7. Re-tighten anchor to 44 Foot-Pounds (60Nm).
34