Stihl MSE 141 C Instruction Manual page 12

English
– Check chain tension periodically thereafter at
regular intervals (only after engaging the chain brake
and disconnecting the chain saw from the power
supply).
– Never cut with a loose chain. If the chain becomes
loose while cutting, switch off the motor, engage the
chain brake and disconnect the chain saw from the
power supply before tightening the chain. Never
attempt to adjust the chain while the chain saw is
connected to the power supply.
￭ Using a chain saw that is modified, damaged, improperly
adjusted or maintained, or not completely and securely
assembled can lead to a malfunction and increase the risk
of serious personal injury or death.
– Never operate a chain saw that is modified,
damaged, improperly maintained or not completely
and securely assembled.
– Always check your chain saw for proper condition
and operation before starting work, particularly the
trigger switch, trigger switch lockout, front hand
guard, chain brake and cutting attachment.
– Ensure that the trigger switch and trigger switch
lockout move freely and always spring back to the
locked position when released. The trigger switch
must not engage until the trigger switch lockout is
depressed.
– Never attempt to modify or override the controls or
safety devices in any way.
– If your saw or any part is damaged or does not
function properly, take it to your authorized STIHL
servicing dealer. Do not use the saw until the
problem has been corrected.
10
5 IMPORTANT SAFETY INSTRUCTIONS
￭ Before connecting the chain saw to the power supply:
– Read and follow the instructions on switching on the
chain saw, @ 13.1.
￭ To help reduce the risk of serious personal injury or death
from unintentional starting:
– Be sure the trigger switch and trigger switch lockout
are in the off position when connecting the chain saw
to the power supply.
– Never carry the chain saw with your finger on the
trigger switch.
– Release the trigger switch and trigger switch lockout
and engage the chain brake before disconnecting
the chain saw from the power supply.
– Engage the chain brake and disconnect the chain
saw from the power supply before assembling,
transporting, adjusting, inspecting, cleaning,
servicing, maintaining or storing the chain saw and
any other time it is not in use.
– Never leave the chain saw unattended when it is
connected to the power supply.
￭ Before disengaging the chain brake and switching on your
chain saw, take the following steps to reduce the risk of
personal injury from reactive forces, loss of control or
inadvertent contact with the chain:
– Be sure that the guide bar and chain are clear of you
and all other obstructions and objects, including the
ground.
– Never attempt to switch on the chain saw when the
guide bar is in a cut or kerf. Doing so could lead to
reactive forces and injury.
– Read and follow the instructions on switching on the
chain saw, @ 13.1.
0458-729-8221-A