Initial Operation; Fitting/Changing The Saw Blade; Fitting The Rip Fence; Connecting The Sawdust Extraction Device - Parkside PSTD 800 B2 Manual

Initial operation

Fitting/changing the saw blade

Always remove the plug from the power socket
before working on the appliance.
♦ Remove the pivoting blade guard
♦ Turn the quick-release chuck
this position.
♦ Push the required saw blade into the quick-
release chuck as far as the limit stop.
♦ Release the quick-release chuck
returns to its initial position. The saw blade is
now locked.
■ WARNING! The saw blade teeth must point
forwards at this point (see foldout page)!
♦ Replace the pivoting guard
appliance.

Fitting the rip fence

The rip fence can be fitted on the left or right of
the appliance.
♦ Undo both the clamping screws on the insertion
openings .
♦ Push the rip fence
♦ Retighten the two locking screws.
Connecting the sawdust extraction
device
♦ Push the reducer
until it is secured.
♦ Attach an approved dust and sawdust extrac-
tor to the reducer
directly.

Fitting the sliding shoe

When working on sensitive surfaces, you can fit
the sliding shoe on the footplate
scratching the surface.
♦ Mount the sliding shoe
and press it up at the back until it clicks into
place on the footplate
♦ To remove the sliding shoe
rear of the footplate
│ GB │ MT
■ 44
.
and hold it in
so that it
back onto the
into the insertion openings
into the extraction nozzle
or extraction nozzle
to prevent
onto the footplate
.
, unfasten it at the
and slide it off the front.

Fitting the splinter guard

The splinter guard
face while sawing wood . The splinter guard
only be used for certain saw blade types, with the
sliding shoe and only for cutting angles of 0°.
♦ Press the splinter guard
sliding shoe

Adjusting the laser

♦ If the laser line is not vertical in the notch
can adjust it by adjusting the position of screw
.

Operation

Setting the cutting angle

♦ Undo the clamping screws
key and pull the footplate
♦ Adjust the cutting angle to 0°/15°/30°/45°
with the aid of the markings on the footplate
Push the footplate
locking pin engages in the toothing
♦ Retighten the clamping screws
key .
NOTE
.
► When using a cutting angle of 15°/30°/45°,
the pivoting blade guard
must be detached beforehand!

Setting the stroke rate

♦ Use the stroke rate adjusting wheel
required stroke rate.

Adjusting the pendulum stroke

♦ You can use the pendulum stroke switch
adjust the pendular movement of the saw blade
. You can achieve fine, clean-cut edges with-
out pendular movement (setting "0"). Deactivate
pendular movement when working on thin
workpieces. You can achieve an increasingly
fast work rate if the pendulum stroke is activated
(settings 1–3).
can prevent fraying of the sur-
from below into the
(arrow facing upwards).
with the hex
to the rear.
to the front so that the
with the Hex
and splinter guard
PSTD 800 B2
can
, you
.
.
to set the
to