Uniden BCD396T Manual page 38

Easier to Read BCD396T/UBCD396T Digital Scanner Manual
Set CC Alert/Beep/Pause
lets you select how the scanner alerts you when it receives a Close Call signal. Pause lets you select how long the scanner waits after a hit
before it returns to the previous operation.
Scroll to 'Set CC Alert' and press E/yes.
At 'Set CC Alert' scroll to 'Select Mode' and press E/yes.
At 'Select Mode' scroll the mode you prefer and press E/yes.
Beep, the scanner beeps when it receives a Close Call signal.
Light, the backlight turns on when it receives a Close Call signal.
Beep+Light, the scanner beeps and the backlight turns on when it receives a Close Call signal.
None, the scanner does not alert.
Scroll to 'Select Beep' and press E/yes.
At 'Select Beep' scroll to
At 'Set Level' scroll to
Scroll to 'Set CC Pause' and press E/yes.
Scroll to '3, 5, 10, 15, 30, 45, 60 sec, or Infinite' and press E/yes.
Press Menu to return.
Set CC Override
lets you select how the Close Call feature works while scanning or searching. This setting has no effect in 'Close Call Only' mode.
Scroll to 'Set CC Override' and press E/yes.
Scroll to On or Off and press E/yes.
With this feature
'CC Found!' and 'Press Any Key' appear for the length of time set in
With this feature
'CC Found!' and 'Press Func Key' appear for the length of time set in
Set Close Call Mode this turns Close Call on when scanning or searching. You can also do this by pressing and holding Func then pressing Hold while scanning or
searching.
Scroll to 'Set CC Mode' and press E/yes.
Scroll to 1 of 3 modes and press E/yes to save and exit.
Off- Close Call is turned off.
CC DND- (Requires firmware 3.00 or newer) Close Call checks for frequencies every two seconds between transmissions.
Pri- Close Call checks for frequencies every two seconds.
Close Call Only
this setting puts the scanner in Close Call Only mode. The scanner will not scan or search programmed frequencies.
At 'Close Call Only' press E/yes.
Press Scan/Srch to exit.
Using Close Call Modes
To start Close Call Only mode press Menu. Scroll to 'Close Call' and press E/yes. At 'Close Call Only' press E/yes.
To use Close Call while scanning or
Managing Close Call Hits
In Close Call Only mode:
http://marksscanners.com/396/396.shtml (38 of 51)8/17/2010 10:11:40 PM
or Off' and press E/yes.
'Alert 1-9
or Auto' and press E/yes.
'Level 1-15
On, when the scanner detects a Close Call signal while scanning, the scanner overrides the current audio with the Close Call hit.
Off, when the scanner detects a Close Call signal while scanning, the scanner does not override the current audio.
searching, press and hold Func then Hold/
Close Call Pause (or until the signal is lost if longer).
Close Call Pause.
to toggle Close Call Priority, Close Call DND, or Off.
Contents
Contents