Uniden BCD396T Manual page 19

Easier to Read BCD396T/UBCD396T Digital Scanner Manual
Note:
Pressing
the first
number
of a 2-
digit
quick
key will
get you
closer,
1 for
10, 2
for 20,
etc.
Set Lockout
determines whether a system will be scanned or not even if the quick key for the system is turned on. The default setting is unlocked.
Scroll to 'Set Lockout' and press E/yes.
Scroll to 'Locked' or 'Unlocked' and press E/yes to save and exit.
Set Hold Time
sets (in seconds) the amount of time the scanner will scan the system before moving on to the next (unlocked) system. If you select 0 for trunking
systems, the scanner stays on the system for at least 1 second. For conventional systems, all unlocked channels will be scanned at least once regardless of this setting.
The scanner moves to the next system after the hold time expires, any current transmission ends, and the channel delay time expires. The default setting is 2 seconds for
each system.
Tip: set your systems to 0.
Scroll to 'Set Hold Time' and press E/yes.
Enter the hold time (0-255 seconds) you desire and press E/yes to save and exit.
Set Delay Time
for the system sets (in seconds) the amount of time the scanner stays on a channel after the transmission has ended before resuming scanning. This
setting applies to all channels in the system. You cannot set the delay on a 'per channel' basis. The default setting is 2 seconds.
Scroll to 'Set Delay Time' and press E/yes.
Scroll to the desired delay time (1-5 seconds or Off) and press E/yes to save and exit.
Set Data Skip (Conventional only)
scanning automatically. With the setting set to off, the scanner remains on the channel until the transmission stops. The default setting is off.
Scroll to 'Set Data Skip' and press E/yes.
Scroll to On or Off and press E/yes to save and exit.
ID Scan/Search
sets whether the scanner scans the programmed ID groups (ID Scan) or searches for all IDs (ID Search) in a trunking system. The default setting is ID
search.
Note: You can also do this while scanning the system by pressing SCAN while scanning the trunked system.
Scroll to 'ID Scan/Search' and press E/yes.
Scroll to 'ID Scan' or 'ID Search' and press E/yes to save and exit.
http://marksscanners.com/396/396.shtml (19 of 51)8/17/2010 10:11:40 PM
with the setting set to on, when it receives a data signal, the scanner stops briefly on the channel, then immediately resumes
Contents
Contents