Before Operating; Check The Engine Oil; Check The Cooling System - Toro REELMASTER 6700-D Operator's Manual

Before Operating

Before servicing or making adjustments to the machine, stop
the engine and remove the key from the switch.
CHECK THE ENGINE OIL (Fig. 2 & 3)
Crankcase capacity is 5 l with filter.
1. Park the machine on a level surface. Release the hood
latch and open the hood.
2. Remove the dipstick from the tube cap, wipe clean and
reinstall the dipstick into the tube cap. Pull it out again
and check the oil level on the dipstick: The oil level must
always be in the notch area on the dipstick.
3. If the oil level is low, remove the tube cap and add SAE
15W-40 CD oil until the level reaches top of notch on the
dipstick. DO NOT OVERFILL.
4. Install the oil tube cap.
5. Close the hood and secure the latch.

CHECK THE COOLING SYSTEM

(Fig. 4)
If the engine has been running, pressurized hot coolant can
escape and cause burns if the degasser cap is removed.
Allow the engine to cool at least 15 minutes or until the
degasser cap is cool enough to touch without burning your
hand.
Capacity of the system is 13 l.
Check the cooling system if the low water level light illumi-
nates.
1. Park the machine on a level surface. Release the hood
latch and open the hood.
2. Remove the degasser tank cap and check the coolant
level. The level should be up to or above the tabs in the
degasser tank, when the engine is cold.
10
CAUTION
CAUTION
Figure 2
1. Hood latch
Figure 3
1. Dipstick/tube cap
Figure 4
1. Degasser tank