1-4 Installation
Servo Oil Pump
Install the servo oil pump in an environment with the following conditions to ensure safe product
operation:
Conditions of Operation
Environment
The figure below shows that HES version A is installed on the machine. The screws must be
secured to the rubber mat to fixate the servo oil pump. It is recommended to add iron bars as the
support of the hybrid servo motor.
HES version A:
Installation Space
10cm
[4inch]
Since heat is generated as the hybrid servo motor is running, certain space must be reserved to
ensure good circulation of the cooling air as shown in the figure above.
When the hybrid servo motor is running, the temperature of the external cover will reach to about
100°C. Do not touch it with hand to avoid burns.
NOTE
Do not let any foreign objects such as fiber, paper pieces, wood chips or metal pieces to adhere to the cooling
fan of the hybrid servo motor.
Ambient Temperature
Relative Humidity
Oil Temperature
Rubber M at*4
10cm
[4 inch]
Installation Distance
1-9
Chapter 1 Use and InstallationHES Series
0°C~ 40°C
20%~90%, No condensation
0°C~ 60°C (15°C~ 50°C is recommended)
Iron bar
10cm
[4inch]