Checking The Belt Drive And Taper Lock Hardware; Removing The Cutting Unit From The Machine - Toro F60 Operator's Manual

Checking the Belt Drive and
Taper Lock Hardware
Service Interval: Every 250 hours—Ensure that the
belt drive and taper-lock bushing set
screws are tightened to the correct
torque.
1. Park the machine on a level surface, lower the
cutting unit, engage the parking brake, shut off
the engine, and remove the key.
2. Remove the belt cover
3. Tighten the set screws securing the taper-lock
bushings to 30 N∙m (41 ft-lb).
Figure 29
1. Taper-lock bushing
4. Install the belt cover.
(Figure 26).
g319569
2. Set screws
Removing the Cutting Unit
from the Machine
1. Park the machine on a level surface, lower the
cutting unit, engage the parking brake, shut off
the engine, and remove the key.
2. Disconnect the PTO shaft yoke from the cutting
unit gearbox shaft as shown in
3. Remove the lynch pins and pins securing the
cutting unit to the lift arms
1. Lift arm pin
4. Move the machine away from the cutting unit.
21
Figure 16.
(Figure 30).
Figure 30
2. Lynch pin
g313418