Table of Contents
Advertisement
Belt Maintenance
Inspecting the Belts
Service Interval: Every 100 hours—Inspect all belts
for cracks and wear.
Check belts for cracks, frayed edges, burn marks or any
other damage. Replace damaged belts.
Replacing the Mower Belt
The signs of a worn mower belt are squealing while the
belt is rotating, blades slipping while you are cutting
grass, frayed belt edges, burn marks, and cracks. Replace
the mower belt if you detect any of these signs.
1. Disengage the PTO, move the motion control levers
to the neutral locked position, and set the parking
brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Remove 2 bolts and washers in each belt cover and
remove the belt covers over the outside spindles
(Figure 44).
4. Pull on the idler arm to relieve the belt tension on
the left spindle pulley (Figure 42 or Figure 43).
5. Remove the old belt.
6. Install the new belt around the pulleys (Figure 42
or Figure 43).
7. Install the belt onto the spring loaded idler pulley.
Figure 42
34 inch Mower
1. Fixed idler pulley
2. Left spindle pulley
3. Mower belt
4. Spring-loaded idler arm
1. Fixed idler pulley
2. Left spindle pulley
8. Install the belt covers over the outside spindles
(Figure 44).
Note: Non-commercial owners will need to install
the front washer and bolt that holds the belt cover
in place.
40 inch mower shown
1. Left belt cover
2. Right belt cover
Checking and Replacing the
Pump Drive Belt
Service Interval: Every 50 hours—Check pump drive
belt.
1. Push the seat forwad and locate the pump drive belt.
35
Figure 43
40 inch Mower
3. Mower belt
4. Spring-loaded idler arm
Figure 44
3. Washer
4. Bolt
Advertisement
Table of Contents
