Fujitsu PRIMERGY TX600 S2 Options Manual page 60

Installing controllers
Figure 42: Installing a non-hot-plug controller
Ê Insert the controller in the slot and press it in carefully. Then close the locking
mechanism of the slot (A).
Ê If necessary, plug in the cables on the board and other components.
Ê Close the server, plug in the power plugs, and switch on the server as
described in the
56
A
chapter "Completion" on page
Options Guide
Controllers in non-hot-plug PCI slots
69f.
U41612-J-Z156-2-76