Whirlpool RF3300W Use & Care Manual page 16

Replacing
Burn, ElecMcal Shock and Fire Hazard
,
l
Make sure all rurtace units are OFF before replaclng surface units and
mflecfor bowls. Failure to do so can result In burns or elecMcal shock.
l
Do not line the reflector bowls with toll. Fire or electrlcal shock
could result.
1.
Turn off ali surface units.
2. Line up openings in the reflector
bowl with the surface unit recep-
tacle and the element hold dowr
clip.
1
3. Hold the surface unit as level as
possible with the terminal just
started into the receptacle. Push
the surface unit terminal into the
receptacle.
1. When terminal is pushed into the
receptacle as far as it will go, push
down the edge of the surface unit
opposite the receptacle. The ele-
ment hold down clip will keep the
surface unit from moving around.
NOTE: Reflector bowls reflect heat back to the utensils on the surface
unlts. They also help catch spills. When they are kept clean, they reflect
heat better and look new longer.
If a reflector bowl gets dlscolored, some of the utensils may not be flat
enough, or some may be too large for the surface unit. In either case,
some of the heat that's meant to go Into or around a utensil goes down
and heats the reflector bowl. This extra heat can discolor lt. See
Cooklng Gulde for further lnformatlon.
16