Silencing And Reporting Alarms; Silencing An Alarm; To Silence An Alarm - Bosch D720 User Manual

Silencing an Alarm

The audible alarm sounds for a specific period of time before it automatically
shuts off. If an alarm occurs and you want to silence the bell or siren before the
time expires, simply enter your personal passcode and press [ENT].
After silencing the alarm and returning points to normal, you can clear the alarm
memory lights by entering your passcode twice (arm and disarm). On some
systems the alarm memory lights are cleared by entering COMMAND 4.

To Silence an alarm:

Enter your personal passcode and press [ENT].
Note: Some security systems are programmed so bells or sirens cannot be silenced
until the point is restored to a normal (non-alarm) condition.
Reporting to the Central Station
My system reports to a Central Station.
My system does not report to a Central Station.
Your system is programmed to send a closing report to your security company
when arming.
My system sends a Closing Report.
My system does not send a Closing Report.
Your system is programmed to send an Opening Report to your security
company when disarming.
My system sends an Opening Report.
My system does not send an Opening Report.
Your system is programmed to report Force Arming to your security company.
Force Arming is reported to my security company.
Force Arming is not reported to my security company.
Your security system automatically disconnects your telephone from its line when
transmitting reports to your security company. This prevents reports from being
interrupted during transmission. Once the report is completed, the telephone line
is restored to normal service.
Note: If damage occurs to the telephone line and your telephone service is
interrupted, reports are not transmitted to your security company unless an
alternate means of transmitting signals is installed in your system.
8