Table of Contents
Advertisement
Available languages
Available languages
Style 1 - Electronic Oven Controls (on some models)
A
L
K
J
I
A. Display
B. Timer
C. Clock
D. Oven light pad (on some
models)
E. Cancel
F. Start (control lock)
Style 2 - Electronic Oven Controls (on some models)
A
K
J
I
H
A. Oven display
B. Clock
C. Timer/cancel
D. Start/enter (control lock)
E. Auto clean
F. Off/cancel
Display
When power is first supplied to the appliance, "PF" or a flashing
time will appear on the display. Press CANCEL or OFF/CANCEL
to clear "PF" or flashing time from the display.
If "PF" or flashing time appears, a power failure has occurred.
Press CANCEL or OFF/CANCEL and reset the clock if needed.
When the oven is not in use, the display shows the time of day.
When performing a timed cook function, the display will show
either hours and minutes, or minutes and seconds.
8
ELECTRONIC OVEN CONTROLS
B
C
D
G
F
E
H
G. Hour/minute (on some
models)
H. Timed cooking
I. Temperature
J. Auto clean
K. Custom broil
L. Bake
B
C D E
F
G
G. Temperature/time
H. Cook time
I. Start time
J. Custom broil
K. Bake
Start or Start/Enter
The Start or Start/Enter pad begins any oven function. If the Start
or Start/Enter pad is not pressed within 5 seconds after pressing
a function pad, the "START?" indicator light will flash as a
reminder. On some models, "START?" will appear on the display.
Depending on your model, if Start or Start/Enter is not pressed
within 1 minute or 5 minutes after pressing a function pad, the
oven display will return to the time of day mode and the
programmed function will be canceled.
Cancel or Off/Cancel
The Cancel or Off/Cancel pad stops any function except the
Clock, Timer and Control Lock.
This is a 12-hour clock and does not show a.m. and p.m.
To Set:
Before setting, make sure the oven and Timer are off.
1. Press CLOCK.
2. Depending on your model, press the HR or MIN or TIME/
TEMP "up" or "down" arrow pads to set the time of day.
3. Press CLOCK or START.
Tones are audible signals, indicating the following:
One tone
Valid pad press
Oven is preheated (long tone)
Function has been entered
Reminder, repeating each minute after the end-of-cycle tones
Three tones
Invalid pad press
Four tones
End of cycle
Reminder Tones: Reminder tones may be turned off. On some
models, press and hold STOP TIME for 5 seconds. "rEP OFF" or
"off" will appear in the display. Repeat to turn reminder tones
back on, and "rEP on" or "on" will appear in the display.
All Tones: All of the above tones are preset on, all except the
end-of-cycle tones can be turned off.
To Turn Off/On (on some models): Press and hold START TIME
for 5 seconds. A tone will sound, and "Snd OFF" will appear on
the display. Repeat to turn tones on, and "Snd on" will appear on
the display.
On some models, only the loudness of the tones can be adjusted.
On other models, the tones cannot be adjusted or turned off.
Tone Pitch: The pitch is preset at high, but can be changed to
low. On some models, only the loudness of the tones can be
adjusted. On other models, the tones cannot be adjusted or
turned off.
To Change (on some models): Press and hold BAKE for
5 seconds. A tone will sound, and "Snd LO" will appear on the
display. Repeat to change, and "Snd Hi" will appear on display.
Clock
Tones
Advertisement
Table of Contents
