Whirlpool IEL730C Installation Instructions Manual

Whirlpool IEL730C Installation Instructions Manual

30" (76.0 cm) slide-in electric ranges
Hide thumbs Also See for IEL730C:
Table of Contents

Advertisement

Available languages

Available languages

30" (76.0 CM) SLIDE-IN ELECTRIC RANGES
INSTRUCTIONS D'INSTALLATION DES CUISINIÈRES
ÉLECTRIQUES ENCASTRABLES DE 30" (76,0 CM)
RANGE SAFETY .............................................................................2
INSTALLATION REQUIREMENTS ................................................3
Tools and Parts ............................................................................3
Location Requirements................................................................3
Electrical Requirements - U.S.A. Only.........................................6
Electrical Requirements - Canada Only.......................................7
INSTALLATION INSTRUCTIONS ..................................................8
Unpack Range..............................................................................8
Install Anti-Tip Bracket.................................................................8
Adjust Leveling Legs ....................................................................9
Level Range................................................................................10
Electrical Connection - U.S.A. Only...........................................10
Remove/Replace Drawer ...........................................................16
Oven Door ..................................................................................16
Complete Installation .................................................................17
IMPORTANT:
Save for local electrical inspector's use.
IMPORTANT :
À conserver pour consultation par l'inspecteur local des installations électriques.
W10665255A
INSTALLATION INSTRUCTIONS
Table of Contents/Table des matières
SÉCURITÉ DE LA CUISINIÈRE ...................................................19
EXIGENCES D'INSTALLATION ...................................................20
Outillage et pièces......................................................................20
Exigences d'emplacement.........................................................20
INSTRUCTIONS D'INSTALLATION.............................................24
Déballage de la cuisinière ..........................................................24
Installation de la bride antibasculement ....................................24
Réglage des pieds de nivellement .............................................25
Réglage de l'aplomb de la cuisinière .........................................26
est bien installée et engagée......................................................26
Dépose et repose du tiroir..........................................................27
Porte du four...............................................................................27
Achever l'installation ..................................................................28

Advertisement

Table of Contents
loading

Summary of Contents for Whirlpool IEL730C

  • Page 1: Table Of Contents

    INSTALLATION INSTRUCTIONS 30" (76.0 CM) SLIDE-IN ELECTRIC RANGES INSTRUCTIONS D’INSTALLATION DES CUISINIÈRES ÉLECTRIQUES ENCASTRABLES DE 30" (76,0 CM) Table of Contents/Table des matières RANGE SAFETY ................2 SÉCURITÉ DE LA CUISINIÈRE ...........19 INSTALLATION REQUIREMENTS ..........3 EXIGENCES D’INSTALLATION ...........20 Tools and Parts ................3 Outillage et pièces..............20 Location Requirements..............3 Exigences d’emplacement............20...
  • Page 2: Range Safety

    RANGE SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word “DANGER”...
  • Page 3: Installation Requirements

    KSIB900E “Electrical Requirements” section. MES8880D WEE760H0D Contact a qualified floor covering installer to check that the IEL730C YKSEG700E floor covering can withstand at least 200°F (93°C). WEC530H0D YKSEB900E Use an insulated pad or ¼" (0.64 cm) plywood under range if...
  • Page 4 Mobile Home - Additional Installation Requirements Product Dimensions The installation of this range must conform to the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280 This manual covers several models. Your model may appear (formerly the Federal Standard for Mobile Home Construction different from the models depicted.
  • Page 5: Cabinet Dimensions

    Cabinet Dimensions Cabinet opening dimensions shown are for 25" (64.0 cm) countertop depth, 24" (61.0 cm) base cabinet depth and 36" (91.4 cm) countertop height. IMPORTANT: If installing a range hood or microwave hood combination above the range, follow the range hood or microwave hood combination installation instructions for dimensional clearances above the cooktop surface.
  • Page 6: Electrical Requirements - U.s.a. Only

    Electrical Requirements - U.S.A. Only If codes permit and a separate ground wire is used, it is If connecting to a 3-wire system: recommended that a qualified electrical installer determine that Local codes may permit the use of a UL listed, 3-wire, 250-volt, the ground path and wire gauge are in accordance with local 40- or 50-amp range power supply cord (pigtail).
  • Page 7: Electrical Requirements - Canada Only

    Electrical Requirements - Canada Only Check with a qualified electrical installer if you are not sure WARNING the range is properly grounded. Range Rating* Specified Rating of Power Supply Cord Kit and Circuit Protection 120/240 Volts 120/208 Volts Amps 8.8 - 16.5 KW 7.8 - 12.5 KW 40 or 50** 16.6 - 22.5 KW...
  • Page 8: Installation Instructions

    INSTALLATION INSTRUCTIONS Unpack Range Install Anti-Tip Bracket WARNING WARNING Excessive Weight Hazard Use two or more people to move and install range. Failure to do so can result in back or other injury. 1. Remove shipping materials, tape and film from the range. Keep cardboard bottom under range.
  • Page 9: Adjust Leveling Legs

    4. Drill two ¹⁄₈" (3 mm) holes that correspond to the bracket holes of the determined mounting method. See the following Adjust Leveling Legs illustrations. 1. If range height adjustment is necessary, use a wrench or Floor Mounting pliers to loosen the 4 leveling legs. This may be done with the range on its back or with the range supported on 2 legs after the range has been placed back to a standing position.
  • Page 10: Level Range

    3. Remove plastic tag holding three 10-32 hex nuts from the Level Range middle post of the terminal block. 1. Place level on the oven bottom as indicated in one of the two figures below depending on the size of the level. Check with the level side to side and front to back.
  • Page 11 3-wire connection: Power Supply Cord 4-wire connection: Power Supply Cord Use this method only if local codes permit connecting chassis Use this method for: ground conductor to neutral wire of power supply cord. New branch-circuit installations (1996 NEC) 1. Feed the power supply cord through the strain relief on the Mobile homes cord/conduit plate on bottom of range.
  • Page 12 5. Use ³⁄₈" nut driver to connect the neutral (white) wire to the 2. Remove the lower access cover screws located on the back center terminal block post with one of the 10–32 hex nuts. of the range. Pull the bottom of the cover toward you and out to remove cover from range.
  • Page 13 Direct Wire Installation: Copper or Aluminum Wire 3-wire connection: Direct Wire This range may be connected directly to the fuse disconnect or Use this method only if local codes permit connecting ground circuit breaker box. Depending on your electrical supply, make conductor to neutral supply wire.
  • Page 14 Bare Wire Torque Specifications 4-wire Connection: Direct Wire Attaching terminal lugs to the terminal block - 20 lbs-in. (2.3 N-m) Wire Awg Torque Use this method for: New branch-circuit installations (1996 NEC) 8 gauge copper 25 lbs-in. (2.8 N-m) Mobile homes 6 gauge aluminum 35 lbs-in.
  • Page 15: Verify Anti-Tip Bracket Is Installed And Engaged

    4. Attach terminal lugs to line 1 (black), neutral (white), and line 2 (red) wires. Loosen (do not remove) the setscrew on the front Verify Anti-Tip Bracket is Installed and of the terminal lug and insert exposed wire end through Engaged bottom of terminal lugs.
  • Page 16: Remove/Replace Drawer

    Remove/Replace Drawer Oven Door (on some models) For normal range use, it is not suggested to remove the oven door. However, if removal is necessary, make sure the oven is off Remove all items from inside the baking drawer, warming drawer and cool.
  • Page 17: Complete Installation

    Complete Installation 1. Check that all parts are now installed. If there is an extra part, If range does not operate, check the following: go back through the steps to see which step was skipped. Household fuse is intact and tight; or circuit breaker has not 2.
  • Page 18 Notes...
  • Page 19: Sécurité De La Cuisinière

    SÉCURITÉ DE LA CUISINIÈRE Votre sécurité et celle des autres est très importante. Nous donnons de nombreux messages de sécurité importants dans ce manuel et sur votre appareil ménager. Assurez-vous de toujours lire tous les messages de sécurité et de vous y conformer. Voici le symbole d’alerte de sécurité.
  • Page 20: Exigences D'installation

    Pour le modèle : Afin de supprimer le risque de brûlures ou d’incendie lié au fait de se pencher au-dessus des plaques de cuisson IEL730C JES1450CD chaudes, les placards de rangement au-dessus des plaques WEC530H0D JES1450D doivent être évités.
  • Page 21 IMPORTANT : Afin d’éviter d’endommager les placards, Dimensions du produit consulter l’installateur ou le fabricant des placards pour déterminer si les matériaux utilisés peuvent subir une décoloration, une déstratification ou d’autres dommages. Ce four Ce manuel concerne plusieurs modèles. Votre modèle peut a été...
  • Page 22 Dimensions du placard Les dimensions de l’ouverture entre les placards correspondent à une installation entre des placards de 24" (61,0 cm) de profondeur, avec plan de travail de 25" (64,0 cm) de profondeur et de 36" (91,4 cm) de hauteur. IMPORTANT : En cas d’installation d’une hotte ou d’un ensemble hotte/four à...
  • Page 23: Spécifications Électriques - Canada Seulement

    Spécifications électriques – Canada seulement En cas de doute quant à la qualité de la liaison à la terre de la AVERTISSEMENT cuisinière, consulter un électricien qualifié. Puissance nominale de la Intensité nominale cuisinière* spécifiée du cordon d’alimentation et de la protection du circuit 120/240 volts 120/208 volts...
  • Page 24: Instructions D'installation

    INSTRUCTIONS D’INSTALLATION Déballage de la cuisinière Installation de la bride antibasculement AVERTISSEMENT AVERTISSEMENT Risque du poids excessif Utiliser deux ou plus de personnes pour déplacer et installer la cuisinière. Le non-respect de cette instruction peut causer une blessure au dos ou d'autre blessure. 1.
  • Page 25: Réglage Des Pieds De Nivellement

    4. Percer deux trous de ¹⁄₈" (3 mm) qui correspondent aux trous de la bride selon la méthode de montage déterminée. Voir les Réglage des pieds de nivellement illustrations suivantes. 1. Si un ajustement de la hauteur de la cuisinière est nécessaire, Montage au plancher utiliser une clé...
  • Page 26: Réglage De L'aplomb De La Cuisinière

    3. Tenter d’incliner la cuisinière vers l’avant avec précaution. Réglage de l’aplomb de la cuisinière En cas de résistance immédiate, cela signifie que le pied de la cuisinière est engagé dans la bride antibasculement. 1. En fonction de la taille du niveau, le placer sur le bas du four Passer à...
  • Page 27: Dépose Et Repose Du Tiroir

    Dépose et repose du tiroir Porte du four (sur certains modèles) Il n’est pas recommandé d’enlever la porte du four pour une utilisation normale. Toutefois, si la dépose est nécessaire, Enlever tous les articles de l’intérieur du tiroir de cuisson, tiroir- s’assurer que le four est éteint et froid.
  • Page 28: Achever L'installation

    Achever l’installation 1. Vérifier que toutes les pièces sont maintenant installées. S’il Si la cuisinière ne fonctionne pas, contrôler ce qui suit : reste une pièce, passer en revue les différentes étapes pour Les fusibles du domicile sont intacts et serrés; le disjoncteur découvrir laquelle aurait été...
  • Page 29 Notes...
  • Page 30 Notes...
  • Page 31 Notes...
  • Page 32 W10665255A © 2014. 2/14 All rights reserved. Used under license in Canada Printed in U.S.A. Tous droits réservés. Utilisé sous licence au Canada. Imprimé aux É.-U.

Table of Contents