Table of Contents
Advertisement
Before cleaning, turn the heater off, and disconnect from the mains
supply. The heater may then be cleaned using a damp cloth with a drop
of washing-up liquid to remove any dust or dirt from the case. Do no use
stronger detergents or solvents as these may damage the plastic.
Using a dry 1" (25mm) paint-brush, remove any dust from the grilles.
If the mains lead is damaged, it must be replaced by the manufacturer or
and authorised service centre.
If the mains plug needs to be replaced, proceed as follows:
The EH1331 has an overheat protection switch, which disconnects the
power if the element gets too hot. The usual reason for this is because
the air-flow has been obstructed, or the grilles have been blocked. If the
heater ceases to operate, leave it for 20 minutes to cool down, then
check that the grilles are not being obstructed.
Switch back on, and check that the unit is operating normally. If not,
contact an authorised service agent for repair.
You must not dispose of this appliance with domestic household waste.
Most local authorities have specific collection system for appliances and
disposal is free of charge to the end-user.
When replacing an existing appliance with a similar new appliance your
retailer may take the old appliance for disposal.
MAINTENANCE
FAULT-FINDING
DISPOSAL AND RECYCLING
Page 7
• Connect the brown wire to the
terminal labelled "L".
• Connect the blue wire to the terminal
labelled "N".
• Connect the green/yellow wire to the
terminal labelled with the earth symbol
or "E".
• Make sure that the cord-grip is
positioned correctly (over the outer
sheath of the cable) and it fully
tightened.
Advertisement
Table of Contents
