Using The Timer - Prem-I-Air Elite EH1331 Instructions Manual

Convector heater with turbo fan
Table of Contents

Advertisement

The numbers around the timer dial show the time in 24-hour clock.The
timer is controlled by the plastic segments - each segment represents 15
minutes. Move the segment outwards if the heater should be ON for that
time period, or inwards towards the centre of the dial if it should be OFF.
Rotate the dial clockwise until the arrowhead at the right of the dial points
to the current time.
To use the heater in timed mode, it should be permanently connected to
the mains supply. If the power is disconnected, the clock will stop.
At time of going to press, the average cost of electricity is £0.12 per unit
(kilowatt-hour). The amount you are being charged will be shown on your
electricity bill.
At this cost, the EH1331 will cost £0.24 per hour to run with the
thermostat set to its maximum.
If the thermostat is used to regulate the temperature the operating costs
will be lower, depending on the room temperature.

USING THE TIMER

When the timer switch is in this
position,
permanently OFF.
the summer when a permanently installed
heater is not required.
When the timer switch is in this
position, the heater will be
controlled by the timer.
When the timer switch is in this
position,
permanently ON.
OPERATING COSTS
Page 6
the
heater
Use this position in
the
heater
will
be
will

Advertisement

Table of Contents
loading

Table of Contents