Using The Thermostat; Maintenance - Prem-I-Air EH1434 Manual

USING THE THERMOSTAT

The thermostat can be use to regulate the room
temperature.
Turn both switches on (high heat), and rotate the
temperature control fully clockwise.
The heater will then operate at maximum output. When the
desired temperature is reached, rotate the temperature
control anticlockwise until a click is heard. The heater will
then switch on and off to keep the room at the desired
temperature. The indicator lights in the switches will show
that this is happening.
Any of the heat settings may be used.
If the temperature control is rotated fully anticlockwise to the
snowflake symbol, it will operate as a "frost-stat" and switch
the heater on if the temperature drops below 4°C, preventing
damage by frost.

MAINTENANCE

Before cleaning, turn the heater off, and disconnect from the
mains supply. The heater may then be cleaned using a
damp cloth with a drop of washing-up liquid to remove any
dust or dirt from the case. Do no use stronger detergents or
solvents as these may damage the paint finish.
Using a dry 1" (25mm) paint-brush, remove any dust from
the grilles.
If the mains lead is damaged, it must be replaced by the
manufacturer or and authorised service centre. If the mains
plug needs to be replaced, proceed as follows:
Page 6