Before Use - Prem-I-Air EH1530 Manual

IMPORTANT
Installer and Users please note:
These instructions should be read carefully and left with the user of the product
for future reference.

BEFORE USE

You must inspect the appliance including its cable and plug for any signs of
damage. If the product is damaged, DO NOT use it, and contact your supplier
immediately.
INSTALLATION
The EH1530 is designed for wall mounting or for free standing use.
For use in a bathroom, it must be wall mounted, and should be installed by a
qualified electrician. Remove the 13 A plug, and connected to the mains supply
via a fused spur.
To wall mount, proceed as follows:
Referring to the diagram opposite, draw two vertical lines on the wall 250mm
(9¾") apart.
Drill the lower fixing holes on each line at least 50mm (2") from the floor, and
insert a plastic wall-plug.
Drill the four upper fixing holes on each line 135mm and 185mm above the lower
fixing hole, insert a plastic wall-plug into the hole, and screw a fixing screw into
each hole, but do not fully tigten.
Hang the heater on the four upper screws. Then fix the lower brackets with the
two remaining screws.
For free-standing use, attach the feet to the underside using the screws provided.
Page 2