Honda HSM1336i Owner's Manual page 90

SERVICING YOUR SNOW BLOWER
4. Inspect the spark plug. Replace it
if the electrodes are worn or if the
insulator is cracked, chipped, or
fouled.
5. Measure the plug gap with a
wire-type feeler gauge. Correct as
necessary by carefully bending the
side electrode.
The gap should be:
0.028—0.031 in (0.7—0.8 mm)
6. Make sure that the spark plug
sealing washer is in good condition,
and thread the spark plug in by hand
to prevent cross-threading.
7. After the spark plug is seated, tighten with a spark plug wrench to
compress the washer.
If installing a new spark plug, tighten 1/2 turn after the spark plug
seats to compress the washer. If reinstalling a used spark plug,
tighten 1/8 to 1/4 turn after the spark plug seats.
TORQUE: 18 N∙m (1.8 kgf∙m, 13 lbf∙ft)
The spark plug must be securely tightened. An improperly tightened
spark plug can become very hot and may damage the engine.
8. Attach the spark plug cap.
88
SIDE ELECTRODE
0.028 – 0.031in
(0.7 – 0.8mm)
SEALING
WASHER
INSULATOR