Auger Housing Initial Position (Usa Model Only) - Honda HSM1336i Owner's Manual

Auger Housing Initial Position (USA model only)

This snow blower allows you to change the auger housing initial
position (the position where the auger housing returns when you
push the reset switch) as needed.
Change the initial position (auger housing return position set at
present) in case of the following:
1. When you do not want to lower the auger housing to be level to the
ground, as the gravel can be caught in the auger during clearing on
a graveled ground.
2. When the scraper/skid position was changed, making the initial
position no longer adequate for clearing the snow.
3. When each part of the snow blower is worn, making the initial
position no longer adequate for clearing the snow.
4. When you want to change the initial position to a position you want.
Park the snow blower on firm, level ground to change the initial
position.
Push for 5 sec. or longer
RESET SWITCH
CONTROLS & FEATURES
– 1.Turn the engine switch to the ON
position (see page 45).
– 2.Push the reset switch and hold it
pushed for five seconds or longer.
• The auger housing moves to the
initial position by pushing the
reset switch. Keep pushing the
reset switch.
– 3.Release the reset switch and check
whether the reset switch indicator is
blinking.
31