Honda HSM1336i Owner's Manual page 53

Table of Contents

Use the LOW position (i.e. position for clearing hardened snow) only

for clearing hardened snow. Do not set the auger housing in this

position while clearing soft snow or clearing on a bumpy road. This

can damage the road surface or cause stones to be thrown out of the

auger, which is very dangerous. Also, it can cause excessive wear and

damage to the snow clearing part of the snow blower.

• When the mode selector switch is in AUTO or POWER, the auger

housing automatically rises while going in reverse.

USA model only:

In case the auger clutch switch is in the ON position, the auger is

automatically returned to the original position when the snow

blower is transporting forward again.

• If you want to stop the automatic movement of the auger housing,

change the mode selector switch to the MANUAL position.

• To stop the automatic movement of the auger housing, push the

control switch once to the opposite direction of the movement.

• Frequent operation of the auger housing control switch activates the

protection function and makes the drive control warning indicator

(orange) blink, which prevents you from adjusting the snow clearing

part of the snow blower. Stop operating the auger housing control

switch and wait a few seconds before operating the switch again.

OPERATION

Table of Contents