Removing Memory Modules - Dell PowerEdge 1750 Installation And Troubleshooting Manual

After the system completes the POST routine, it runs a memory test. The system detects that the new memory does not match the system configuration
information and displays an error message.
6. Press <F2> to enter the System Setup program, and check the System Memory setting on the System Setup screens.
The system should have already changed the value in the System Memory setting to reflect the newly installed memory.
7. If the System Memory value is incorrect, one or more of the memory modules may not be installed properly. Repeat step 1 through step 6, checking to
make sure that the memory modules are firmly seated in their sockets.
8. Run the system memory test in the system diagnostics.
Installing Memory Modules
To install a memory module, perform the following steps:
1. To open the memory module socket, press down and outward on the socket latches. See Figure 6-4.
Figure 6-4. Installing a Memory Module
2. Align the memory module's edge connector with the slot in the center of the memory module socket, and insert the memory module straight down into
the socket. See Figure 6-4.
The module and the socket are keyed to prevent misalignment.
3. Press down on the memory module with your thumbs until the latches snap up around the module, securing it. See Figure 6-4.
When the memory module is properly seated in the socket, the latches on the memory module socket should align with the latches on the other sockets
with memory modules installed.
4. Repeat step 1 through step 3 of this procedure to install the remaining memory modules.
5. Perform step 4 through step 8 of

Removing Memory Modules

To remove a memory module, press down and outward on the socket latches on each end of the socket until the memory module pops out of the socket. See
Figure 6-5.
Figure 6-5. Removing Memory Modules
"Performing a Memory Module Upgrade."