Network Cable Requirements - Dell PowerEdge 1750 Installation And Troubleshooting Manual

Table B-7. NIC Connector Pin Assignments
Pin Signal I/O Definition
1 TP0+ I/O Data0 (+)
2 TP0– I/O Data0 (–)
3 TP1+ I/O Data1 (+)
4 TP2+ I/O Data2 (+)
5 TP2– I/O Data2 (–)
6 TP1– I/O Data1 (–)
7 TP3+ I/O Data3 (+)
8 TP3– I/O Data3 (–)

Network Cable Requirements

The NIC supports a UTP Ethernet cable equipped with a standard RJ45-compatible plug. Observe the following cabling restrictions.
NOTICE: To avoid line interference, voice and data lines must be in separate sheaths.
Use Category 5 or greater wiring and connectors.
l
Do not exceed a cable run length (from a workstation to a hub) of 100 m (328 ft).
l
For detailed guidelines on operation of a network, see "Systems Considerations of Multi-Segment Networks" in the IEEE 802.3 standard.
Back to Contents Page