Table of Contents
Advertisement
7
HYDRAN 201TI INSTALLATION
Please read the following Sections before proceeding with the installation:
• User interface, in Section 5.1.
• General warnings, in Section 6.1.
• Installation overview, in Section 6.2.
Note: It is recommended to use the Hydran Host software rather than the H201Ti's user
interface (keypad and display). See the Hydran Host Software Manual.
7.1
Incoming Inspection and Verification
It is strongly recommended to verify the operation of the H201Ti's and Hydran 201Ci
Controllers before their installation. This verification also confirms that no damage
occurred during shipping and allows the user to become familiar with the Hydran 201i
System. The H201Ti installation procedure is described in Section 7.3.
7.1.1 Receiving and Unpacking
Upon receipt, the shipping box contains one preassembled H201Ti, complete with a
transmitter enclosure, a Hydran 201 sensor, electronic modules (CPU and I/O), and a
flanged brass adaptor. For the shipping list, see Section 7.1.2 below; for a detailed view
of the component assembly of the H201Ti, see Figure 7-2.
1. Open the shipping box.
2. Remove the documentation and the small bag containing accessories and tools.
3. Carefully remove the H201Ti from the box.
CAUTION
Note: Keep the packing material for storage or further shipment of the H201Ti.
7.1.2 Shipping List
This Section lists all the items included in the shipment of a Hydran 201Ti. If any item
is missing, contact the General Electric Customer Service (the coordinates can be found
at the bottom of page 2).
1. One pre-assembled H201Ti, including:
• One enclosure, with heating plate, aluminum cover and knob.
• One Hydran 201 sensor.
• One flanged brass adaptor.
• One main (CPU) module, with display and keypad.
Page 94
Do not remove the plastic cap from the flanged brass adaptor.
This cap protects the adaptor's threads and membrane.
Hydran* 201i Instruction Manual
MA-033
Rev. 14.0, 12-Nov-18
Advertisement
Table of Contents
