Table of Contents
Advertisement
Error messages
On the television
No disc.
This is non-recordable disc.
This disc is not formatted properly.
Please format the disc in 'DISC SETTING' to
record.
This disc cannot be read.
Please check write protect tab on the disc.
Contents of this disc are protected.
Cannot finish recording completely.
Cannot record on the disc.
Please set clock.
This disc may not be played in your region.
Your selection exceeds the recorder's rating limit.
On the unit's display
U11
NO DISC
U14
U99
CHK REMOTE
58
RQT6559
≥You haven't inserted a disc.
Correctly insert a disc that this unit can use.
≥The disc is upside down.
If it is a single-sided disc, insert it so the label is facing up.
≥The unit cannot record on the disc you inserted. The unit
cannot record onto finalized DVD-R, DVD-Video, CDs, or
video CDs.
Insert a DVD-RAM or unfinalized DVD-R.
≥You inserted an unformatted DVD-RAM.
Format the disc with this unit.
≥You inserted an incompatible disc. Insert a compatible disc.
≥The write-protect tab on
the cartridge is set to
PROTECT.
Use a ballpoint pen or
similar to release the
write protection.
≥The program is write-protected.
Release the protection with the Direct Navigator.
≥The disc is write-protected.
Release Disc Protection with DISC SETTING.
≥The program was copy-guarded.
≥The disc is full.
≥Recording was not completed for some other reason.
≥The disc is scratched. Use another disc.
≥The disc is dirty.
≥The clock is not set. Set the clock.
≥You tried to play a disc with a region number different from
this unit's region number. This unit can only play discs with
the region numbers compatible with this unit (1, All, or includ-
ing the number 1).
≥A ratings level has been set for DVD-Video with this unit.
Unlock the unit with "Ratings" in "Disc" in the SETUP menu.
≥The disc is dirty or badly scratched.
– Clean the disc if it is dirty.
– The disc cannot be played if it is scratched and this display
doesn't disappear.
≥You have inserted a disc the unit cannot play or record on.
– Insert a disc the unit can play or record on.
≥The unit is hot.
!?
– The unit switches to standby automatically for safety rea-
sons and you cannot operate it. Wait for about 30 minutes
for the service number to disappear.
– Select a position with good ventilation when installing the
unit.
– Do not block the cooling fan on the rear of the unit.
≥The unit fails to operate properly.
– Press [Í, DVD POWER] to switch the unit to standby. Now
press [Í, DVD POWER] again to turn the unit on.
≥The remote control and main unit are using different codes.
– Change the code on the remote control or main unit.
PROTECT
Page
8
17
8
34
8
—
36
34
—
—
—
—
9
54
Cover page
51
9
—
8
—
—
—
—
50
Advertisement
Table of Contents
