Voice Cables - Cisco VG310 Installing Manual

Cable-Connection Procedures and Precautions
Port or Connection
T1/E1
Cisco serial
Cisco Smart serial
Analog voice FXS
Analog voice FXO
Cable-Connection Procedures and Precautions
• Connect each WAN, LAN, and voice cable to the appropriate connector on the chassis or on a network
• Position the cables carefully, so that they do not put strain on the connectors.
• Organize cables in bundles so that cables do not intertwine.
• Inspect the cables to make sure that the routing and bend radius is satisfactory. Reposition cables, if
• Install cable ties in accordance with site requirements.

Voice Cables

Warning
Do not use this product near water; for example, near a bath tub, wash bowl, kitchen sink or laundry tub, in
a wet basement, or near a swimming pool. Statement 1035
Installing the Cisco VG310 and Cisco VG320 Voice Gateways
20
Port Type, Color
RJ-48C/CA81A
RJ-48S, tan
60-pin D-sub, blue
Cisco Smart compact
connector, blue
RJ-11, gray
RJ-11, pink
module or interface card.
necessary.
Installing the Cisco VG310 and Cisco VG320 Voice Gateways
Connection Cable
T1 or E1 network RJ-48 T1/E1
External T1 CSU or other RJ-48S to RJ-48S TE
T1 equipment RJ-48S to RJ-48S NT
RJ-48S to RJ-48S T1
RJ-48S to bare
RJ-48S to BNC
RJ-48S to twinaxial cable
RJ-48S to DB-15
RJ-48S to DB-15 null
CSU/DSU and serial Cisco serial transition
network or equipment cable that matches the
signaling protocol
CSU/DSU and serial
(EIA/TIA-232,
network or equipment
EIA/TIA-449, V.35, X.21,
or EIA-530) and the serial
port operating mode (DTE
or DCE)
Telephone, fax RJ-11; RJ21,
straight-through
Central office, analog
PBX