Cisco VG310 Installing Manual page 25

Installing the Cisco VG310 and Cisco VG320 Voice Gateways
Procedure
Step 1
Read the
Step 2 Press the ejector button next to the CompactFlash memory card. The ejector button moves outward so that it
projects from the panel.
Step 3 Press the ejector button again to eject the CompactFlash memory card partially out of its slot.
Step 4
Pull the memory card out of its slot.
Step 5 Push the ejector button until the button is flush with the chassis.
To prevent damage to the ejector mechanism, the ejector button must remain pressed all the way in (flush
against the bezel) when not being used to eject a CompactFlash memory card.
Figure 13: CompactFlash Memory Card Slot
1
Replacing a CompactFlash Memory Card
Procedure
Step 1
Read the
Step 2 Make sure that the ejector button is fully seated until it is flush with the chassis.
Note
Step 3 Insert the CompactFlash memory card into the slot until it is fully seated. The ejector button remains flush
with the panel.
If the ejector button is projecting from the chassis after you insert the CompactFlash memory card, remove
the CompactFlash memory card, press the ejector button until it clicks, and reinsert the CompactFlash memory
card.
Safety Recommendations
Ejector button
Safety Recommendations
If the ejector button is projecting out from the panel, push it in until it is flush with the chassis.
and disconnect the power supply before you replace any module.
2 CompactFlash memory card slot
and disconnect the power supply before you replace any module.
Installing the Cisco VG310 and Cisco VG320 Voice Gateways
Replacing a CompactFlash Memory Card
25