Table of Contents
Advertisement
gq@- -
L
AIR
SHUTTER
FIG. 9
The air shutters on the top burner manifold should be
adjusted for a proper flame. The flame should be soft
in character. To adjust the air shutter, loosen the lock
screw. Move the air shutter to close the opening to
decrease the air or enlarge the opening for more air.
Tighten the lock screw when the adjustment
is com-
plete. Adjust the air shutter so that the flame has an
inner cone of bluish-green
and an outer mantle of dark
blue. The flame should be solft in charcter.
2. Oven burners
All burners are lighted by electronic ignitors.(See Figure
12) DO NOT attempt to insert any object into the open-
ings of the protective shield surrounding
the ignitor coil.
Do not attempt to clean this area.
a. Lower oven burner
The lower oven burner flame should be l/z" long when
the air shutter is correctly adjusted (See Figure 10). The
lower oven air shutter
is located behind the utility
drawer at the center of the range next to the pressure
regulator.
To adjust the air shutter,
loosen the lock
screw. Move the air shutter to close the opening to
decrease the air or enlarge the opening for more air.
Tighten
the lock screw
when
the adjustment
is
complete.
The appearance of a properly adjusted gas flame is one
having an inner cone of bluish-green and an outer man-
tle of dark blue. The flame characteristics
should be
clean and soft with no yellow tips. Blowing or lifting of
the flame should not occur.
b. Upper oven burner
The upper oven burner flame should be %" long when
the air shutter is correctly adjusted. (See Figure 13.)
The upper oven air shutter
is located
behind
the
control panel on the lower right hand side. To adjust
the air shutter, loosen the lock screw. Move the air shut-
ter to close the opening to decrease the air or enlarge
the opening for more air. Tighten the lock screw when
the adjustment
is complete.
The appearance of a properly adjusted gas flame is one
having an inner cone of bluish-green and an outer man-
tle of dark blue. Flame characteristics
should be clean
but soft.
3. Broiler burner
The burner may have a hazy or fuzzy appearance when
in operation. This haze may be 3/e" thick, maximum and
is normal for this type of burner.
No gas input adjustment
is necessary as the infrared
burner is equipped with a fixed orifice. There is no air
shutter to adjust.
B. Natural to LP gas
conversion
THIS RANGE IS PREADJUSTED
FOR OPERA-
TION ON "NATURAL"
GAS AS SHIPPED FROM
THE FACTORY.
TO USE THE APPLIANCE
ON
"LP"
GAS, DO THE FOLLOWING:
1. Pressure regulator
This range is equipped with one of five different types
of pressure regulators. Use the following as a guide to
convert your pressure regulator to LP gas operation.
NAT.
GAS
FIG. A
LP GAS
Remove the cap marked "NAT."
and reverse it to read
"LP."
Be sure not to disturb or remove the spring
beneath the cap. Also make sure the fiber washer is
between the cap and the body of the regulator.
See
figure A for the correct position of the cap.
8
Advertisement
Table of Contents
