Pressure Rider 970/1030 Bioclip/1200; Mowing Deck; Adjusting Rider 1030 Bioclip/1200 - Husqvarna Rider 850 Workshop Manual

Checking and adjusting mower deck
ground pressure Rider 970/1030
Bioclip/1200
1
Place a set of bathroom scales under the mower
deck's frame (front edge) so that the deck rests on
the scales.
2
Adjust the mowing deck's ground pressure with the
adjuster nuts placed behind the front wheels on
both sides of the ride-on mower. The ground
pressure should be between 12 and 15 kg.
Checking and adjusting mower deck
parallelism
1
Place the ride-on mower on an even surface and
measure the distance between the ground and the
edge of the deck, at the front and rear of the cover.
If the values correspond, the deck is parallel.
2

Adjusting Rider 1030 Bioclip/1200

1
3
• Remove the front cover, as well as the right and
left fenders.
• Unscrew the lock nuts (1) and (2). Note that the
ends of the strut are right respective left-handed.
• Place a key over the chamfering (3) in the middle
of the strut and screw the strut forwards or
backwards to raise or lower the front edge of the
cover.
• Tighten the lock nuts after adjustment.
• After adjustment, the deck's parallelism is to be
checked. Thereafter, re-attach the front cover as
well as the right and left fenders.
Reparation instructions
2
35
English –