Husqvarna Rider 850 Workshop Manual page 16

1
1
Lower the engine and tighten the engine
attachments (two on each side of the engine) with
moment (25 Nm).
2
506 89 92-01
Position the pulley with tool no. 506 79 06-01 and
tighten it with moment (80 Nm). Use tool no. 506 89
92-01 as a holder-on.
3
2
Position the wires in the wire holder, clamp the
holder together and, from below, lead it up through
the centre of the belt tensioner until it hooks over
the tensioner's upper edge.
4
4
506 79 06-01
Attach the throttle and choke wires to the
carburettor and position the wire clamps without
tightening them.
Reparation instructions
15
English –