Checking And Adjusting Steering Wires - Husqvarna Rider 850 Workshop Manual

10
Attach the engine's electrical connections.
11
Tightly screw the cable from the start motor to the
starter relay.
12
Lift the battery into place and fasten the cable
connections and safety guard. Tighten the catching
belt.

Checking and adjusting steering wires

1
Remove the frame plate by releasing the screws
(two on either side).
2
The tension is checked by squeezing together the
wires (as shown in the diagram). Without having to
apply too much force, the wires should be able to
be squeezed to half the distance between them.
3
Stretch the wires by tightening the adjuster nuts
(one wire on each side of the ride-on mower). Do
not overtension them, they should only be tightened
up to the steering rim. Stretch both wires equally so
that the steering wheel position is not changed.
Check the wire tension after adjustments have
been made, in accordance with point 2.
Reparation instructions
17
English –