Removal/Installation Of Gear Box - Husqvarna Rider 850 Workshop Manual

2
Roll the rear frame forwards and press it in on the
swing axle.
3
1
2
4 4
• Attach a washer and circlip onto the swing axle
(1).
• Firmly secure the wires' holder plates (2), as well
as the gear and brake wires (3 and 4).
• Connect the belt onto the pulley and tightly screw
the tensioning wheel arm (5) onto the rear frame.
• Attach the clutch wire (6) and the tensioning
wheel spring (7).
6
6
7 7
5 5
3
4
After installation of the swing axle, lubricate the
lubricating area above the swing axle housing with
molybdenum disulphide grease. Also check that the
wires and controls are correctly adjusted justerade
(see page 20–22). Finally, attach the transmission/
gear box cover.

Removal/installation of gear box

1
• Block-up the machine in front of the rear frame
and dismantle the rear wheels.
• Remove the cover from over the gear box.
Reparation instructions
25
English –