Rear Handle - Husqvarna 136LiHD50 Workshop Manual

6.10.3.2 For products with S/N from: 20180900384
1. Connect cable (A) and make sure that the contact
clicks into place.
2. Assemble the throttle trigger lock and throttle trigger.
3. Assemble the control handle.

6.11 Rear handle

6.11.1 To disassemble the rear handle
WARNING: Make sure the spring does not eject
out and causes injury. Put on protective
goggles.
CAUTION: Do not to damage the cables or the
plugs.
CAUTION: The flat cable to the keypad is very
easily damaged.
456 - 002 - 03.10.2018
A
Note: Hold the parts in position in the handle when you
disassemble it.
1. Carefully lift out the cables, plug (A) and clips (B).
Disconnect the plug.
B
2. Remove the 4 screws and remove the handle from
the chassis.
3. Pull out the handle stop (C) and turn the fastener (D)
1/4 of a turn until it stops.
C
4. Push the plastic catch (E) with a screwdriver until it
goes above the heel. Turn the fastener (D) 1/4 of a
turn until it stops.
Repair instructions 536LiHD60X/
520iHD60, 536LiHD70X/520iHD70 -
A
1
/
4
D
1 /
4
E
25