Gear, Cutting Unit And Gear Housing - Husqvarna 136LiHD50 Workshop Manual

3. Connect the plug from the motor to the control unit.
Attach the plug with the gray cable in position (C).
CAUTION: Make sure that the cables hang
straight down from the plug.
4. Assemble the right half of the chassis and the front
To remove the front handle on page 16
handle. See
To disassemble the chassis on page 15 .
and

6.7 Gear, cutting unit and gear housing

6.7.1 To disassemble the gear, cutting unit and
motor out of the gear housing
1. Remove the 6 screws and remove the bottom plate
of the gear housing.
2
4
1
2. Remove the 2 screws and remove the gears and the
cutting unit from the gear housing.
Note: The front screw locks also the safety point
with the related nut.
20 - Repair instructions
536LiHD60X/520iHD60,
536LiHD70X/520iHD70
C
3
6
5
6.7.2 To disassemble the gears
1. Remove the circlip (A), remove the washer (B),
carefully lift up the hook (C) and remove the cutting
unit.
2. Disconnect the parts as shown in the illustration.
6.7.3 To assemble gears, cutting unit and motor
in the gear housing
Note: Lubricate moving parts on gears and the cutting
unit with grease so they move easily.
Note: Always replace the gasket after you disassemble
the gear housing.
A
B
C
456 - 002 - 03.10.2018