Motor And Gear Package; Keypad - Husqvarna 136LiHD50 Workshop Manual

5.7.2 To assemble the power trigger
1. Put the power trigger (A), the catch (B) and the
spring (C) in their initial positions in the chassis.
Make sure that the start inhibitor is set correctly
against the main switch. Make sure that the spring is
in the groove (D) on the power trigger and in the
space (E).
B
A
2. Assemble the right chassis half and the front handle.

5.8 Motor and gear package

5.8.1 To disassemble the motor and gear
package
1. Disassemble the wear guard, the front handle and
the right chassis half.
2. Remove the gear housing and motor from the
chassis and disconnect the plug.
3. Disassemble the gear housing and remove the gear
package and cutting unit. See
gear housing and remove the cutting unit on page
10 .
5.8.2 To assemble the motor and gear package
1. Put the motor on the gear housing.
2. Put the gear package and cutting unit in the gear
housing and assemble the bottom plate on the gear
To disassemble the gear housing and
housing. See
remove the cutting unit on page 10 .
456 - 002 - 03.10.2018
D
C
E
To disassemble the
3. Connect the plug and put the gear housing and
motor in the chassis. Make sure the cables from the
plug to the motor are put correctly in the chassis.
Make sure that the resistor is put in its correct
position in front of the motor.
4. Assemble the right chassis half and the front handle.

5.9 Keypad

5.9.1 To disassemble the keypad and control
unit
1. Disassemble the wear guard, the front handle and
the right chassis half.
2. Remove the power trigger, the lock and the spring
from the chassis. See
trigger on page 12 .
3. Disconnect the plug to the motor. See
disassemble the motor and gear package on page
13 .
4. Remove the 2 screws for the battery plug.
5. Remove the control unit, the cables with the main
switch and the keypad from the chassis.
6. Disconnect the keypad from the control unit.
5.9.2 To assemble the keypad and control unit
CAUTION: Be careful. The flat cable to the
keypad is easily damaged.
Repair instructions 136 LiHD50 - 13
To disassemble the power
To