Front Handle - Husqvarna 136LiHD50 Workshop Manual

1. Loosen the nut (A) that holds the connection plate
(B).
2. Loosen the nuts (C).
Note: For model 536LiHD60X/520iHD60 and
536LiHD70X/520iHD70 there are 5 nuts. For model
536LiHD60X (US) there are 7 nuts.
3. Remove the blade guard (D) and the connection
plate (B) and disconnect them.
6.3.3 To assemble the cutting unit
• Assemble in the opposite sequence of
disassemble the cutting unit on page 15 . Tightening
Servicing data 536LiHD60X/520iHD60,
torque: see
536LiHD70X/520iHD70 on page 7 .
6.3.4 To lubricate the gearbox
Instructions of lubricating when replacing the cutting
board.
To make sure product efficiency and lifetime the
recommended grease must be used. The recommended
grease is specified in the IPL and has the article number
16 - Repair instructions
536LiHD60X/520iHD60,
536LiHD70X/520iHD70
A
B
C
D
To
503 98 96-03 (20g). The gearbox must not be fully filled
with grease.
• Apply approximately 2.5 g of grease.
1
3

6.4 Front handle

6.4.1 To remove the front handle
CAUTION: Make sure that the cables to the
handle are not damaged when you assemble
the cover.
5
2
4
456 - 002 - 03.10.2018