Shaft - Husqvarna 325iLK Workshop Manual

4. Remove the airflow cover.
5. Assemble in the opposite sequence.

5.3 Shaft

5.3.1 To remove the shaft
1. Loosen the 2 screws that hold the shaft in the motor
bracket.
2. Remove the 2 screws near the shaft on the control
handle.
3. Pull out the shaft.
726 - 002 - 23.01.2020
5.3.2 To install the shaft
1. Push the shaft into the control handle.
2. Turn the shaft axle to make sure that the shaft axle
is connected to the motor axle. Push the shaft more
into the control handle if the shaft axle is not
connected to the motor axle.
Note: Turn the shaft to make the mark on the shaft
align with the screw, if the shaft is reused. A new
shaft do not have this mark.
3. Tighten the 2 screws that hold the shaft in the motor
bracket.
Repair instructions - 11