Section 6 - Brakes; General Information; Troubleshooting; Brake System Troubleshooting - Husqvarna HUV 4214 2009 Maintenance And Service Manual

SECTION 6 – BRAKES

GENERAL INFORMATION

DANGER
• See General Warning on page 1-2.
WARNING
• See General Warning on page 1-2.
CAUTION
• Worn or damaged brake discs cannot be machined to refinish them. Replace as necessary.
This section contains procedures for inspection, troubleshooting, removal, installation, maintenance, and regular
servicing of the hydraulic brake system. In order to properly service and maintain this brake system, it is necessary to
understand the hydraulic circuit and the functions of all components in the system. If any repair or servicing needs to
be performed, we recommend that it be performed by an authorized distributor/dealer using OEM parts.

TROUBLESHOOTING

See General Warning on page 1-2.

BRAKE SYSTEM TROUBLESHOOTING

The procedures used in making the checks provided in the following troubleshooting guide can be found in the
referenced sections of this maintenance and service manual.
TROUBLESHOOTING GUIDE – HYDRAULIC SYSTEM COMPONENTS
SYMPTOM
Low pedal – pedal may go to the floor
TABLE CONTINUED ON NEXT PAGE
2009-2010 HUV 4214, HUV 4414, and HUV 4414X Maintenance and Service Manual
POSSIBLE CAUSES
Excessive clearance between the disc and
brake pads
Leak in the hydraulic system
Air in the hydraulic system
Weak (bulging) brake line
CORRECTIVE ACTION
See Brake Pads and Caliper on page 6-12.
Check the master cylinder, brake lines and
hoses for leaks. Replace all damaged parts
and bleed brake system.
See Bleeding the Hydraulic Brake System
on page 6-16.
Replace the worn hose. See Brake Hose
Replacement on page 6-7.
6
Page 6-1