Brake Pedal Removal - Husqvarna HUV 4214 2009 Maintenance And Service Manual

5

Brake Pedal Removal

2315
Figure 5-17 Fully Turn Throttle Bellcrank Until It Contacts
BRAKE PEDAL REMOVAL
See General Warning on page 1-2.
1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline Vehicles on page 1-4.
2. Remove the under-pedal closeout panel. Drill out rivets and carefully pull the panel out and down over the
pedals.(Figure 5-19, Page 5-8)
CAUTION
• Be sure not to damage any components as a result of the drilling operation.
3. Remove rue pin and clevis pin securing master cylinder push rod to brake pedal (Figure 5-20, Page 5-8).
1179
Figure 5-19 Remove Closeout Panel
Page 5-8 2009-2010 HUV 4214, HUV 4414, and HUV 4414X Maintenance and Service Manual
Tab
ACCELERATOR AND BRAKE PEDAL GROUP
2316
Figure 5-18 Correct Throttle Bellcrank Position With
Accelerator Pedal To Floor
1193
Figure 5-20 Disconnect Master Cylinder Push Rod