Table of Contents
Advertisement
Adjusting
the crisper
cover track
&cause your crispers are not the same
size, your crisper cover has an adjustable
center track so you can swftch positbns of
the crispers.
To remove the center track:
1. Push up the cover insert from the bottom,
then slide out with both hands.
2. Gently pull up on front end of the center
track.
3. Pull rear end of track out of opening in
cover.
To replace the center track:
1. Insert rear end of track (with hole) into
opening in cover.
2. Lower front end of track into slot.
3. Make sure rear end of track has snapped
into place on under side of cover.
Using
the ice cube trays
If cubes are not used, they may shrink. The
moving cold air starts a sbw evapxatbn.
The longer you store cubes, the smaller they
get.
To remove ice:
1. Hold tray at both ends.
2. Twist slightly.
Using
the optional
automatic
ice maker
If your refrigerator has an automatic be
maker, or if you plan to add one later, here
are a few things you will want to know.
l
The ON/OFF lever is a wire signal arm.
DOWN to make be automaticalfy
UP to shut off the be maker
IMPORTANT: Do not turn on the be
maker until it is connected to the water
supply. Instructions
for ks msker water
supply hook up are attached to the
back of the refrigerator cabinet.
12
Advertisement
Table of Contents
